The Bench Log
Notes from our workshop — practical explanations of what actually happens between a fitting session and a finished club in your bag.
Hand-Assembled vs. Factory-Line Clubs
What actually differs, step by step, between a club built on a bench and one built on a conveyor — and why it shows up in how the club plays.
Read article →Reading a Clubwright Build Ticket
Every finished club here leaves with a signed ticket. Here's how to actually read one and why it matters years down the road.
Read article →Head, Shaft, and Grip as One System
Why fitting components independently misses the point — and how treating a club as one assembly changes what we recommend.
Read article →Why We Trim Every Shaft In-House
Pre-trimmed shafts save time. Here's what gets lost when a shop skips cutting its own, and what we check before a single blank goes on the saw.
Read article →The Bench in the Wet Season
What a Puget Sound winter actually does to epoxy cure, grip tape, and finished club storage — and how we schedule around it.
Read article →The Apprenticeship Behind a Clubwright
Why every fitter on staff spends months on assembly before running a session solo, and what that apprenticeship actually looks like.
Read article →Put This Into Practice
Reading about the bench is a start — watching your own build come together is where it actually lands.