The Whole Set, Cut, Bored, and Built by One Hand.
Most "custom fitting" ends with an order number sent to a factory three states away. At Clubwright Lab, the fitting is the start of the job — every head we recommend gets bored, every shaft gets trimmed and epoxied, and every grip gets wound right here on our own bench, by the same person who read your swing.
One Club, Or the Whole Bag — Built the Same Way
Every fitting ends the same place: on our bench, where the head, shaft, and grip you tested get turned into the actual club you take home.
Driver Fitting
Loft, shaft, and head paired for carry and dispersion, then bored and built to the exact spec we land on together.
Learn more →Fairway Wood Fitting
Confidence off the deck and the tee, matched to your attack angle and how you actually take turf.
Learn more →Hybrid Fitting
A long-iron replacement built to launch high and hold, sized to slot cleanly into your existing set.
Learn more →Iron Fitting
Lie, loft, length, and shaft weight mapped across the full set, then bench-checked club by club before pickup.
Learn more →Wedge Fitting
Bounce and grind chosen for how you actually play turf around Tacoma, not a chart written for a different climate.
Learn more →Putter Fitting
Length, lie, loft, and face balance checked against your stroke, then finished on our own putter bench.
Learn more →A Fitting Chart Only Gets You Halfway There
Plenty of shops will hand you a printed spec after a session and point you to a website. That spec is only as good as the hands that turn it into a real club — and a shaft that's rushed through epoxy cure, or a swingweight that drifts club to club, quietly undoes the fitting before you ever swing it on the course.
See the Bench ProcessFour Stations, Start to Finish
Consultation & Swing Read
We talk through your misses and goals, then watch your swing on camera before touching a single component.
Component Selection
Heads and shafts tested side by side from our demo wall, narrowed down against your own numbers.
Hand Assembly
Hosels bored, shafts trimmed and epoxied, grips wound to spec — all on our bench, by the fitter who ran your session.
Verification & Walkthrough
Every finished club is checked on the frequency and swingweight scale, then walked through with you before you leave.
Notes From Clients Who Picked Up Their Own Build
I watched the guy who fit me actually epoxy the heads on my new irons. Never had that happen at a big-box shop, and the gapping is dead consistent from 9 to wedge.
My driver had been rattling for a season and I didn't even know it. They caught a loose ferrule during the build check and rebuilt it before I ever hit it.
The build ticket sits in my bag now. Every spec is right there if I ever need to have a club matched again down the road.
Every Major Head and Shaft Brand, No Quota to Hit
We're not paid to push one manufacturer's numbers, so what ends up in your bag traces back to your fitting data — not a sales target.
Ready to Watch Your Build Come Together?
Sessions run 60–90 minutes and end with a signed build ticket. Fitting fees are credited toward any club we build for you afterward.