Skip to content
CWL Clubwright Lab Bespoke Club Building, Tacoma WA
Fitting Services / Wedge

Wedge Fitting

Wedges live or die on bounce and turf interaction, and Tacoma's soft, wet fairways for a good chunk of the year behave differently than a dry-condition fitting chart assumes. We fit for the turf you actually play.

What We Test

Bounce, Grind, and Attack Angle Together

Bounce works with your attack angle and the firmness of the turf underneath the ball — not as a fixed number that applies everywhere. We test wedges off both a simulated firm lie and a softer, wetter lie closer to what you'll see most of the year around the South Sound, watching how the sole interacts with each.

Once bounce and grind are settled, loft gapping across your wedge set is checked against your actual carry distances, and every wedge is finished and swingweight-matched on our bench before it goes in your bag.

Wedge Build Card
Turf TestedFirm & Soft Lies
Bounce Range6–14°
Loft Gapping4–6° Steps
Grind OptionsFull, Mid, Low
The Variables

What Actually Changes in a Wedge Build

Bounce Angle

Higher bounce resists digging on soft or wet turf; lower bounce suits firmer conditions and players with a shallower attack angle.

Sole Grind

Grind shapes how the sole behaves at address and through varied turf firmness, especially on shots played with an open face.

Loft Gapping

Even 4–6 degree steps between wedges close scoring-distance gaps that a mismatched set leaves wide open.

Shaft Weight

Wedge shafts are often built heavier than the irons above them for more feel and control on partial shots around the green.

Face Texture & Grooves

Groove sharpness affects spin more in wet conditions than dry ones — something worth factoring in if you play year-round here.

Length & Lie

Wedge length and lie angle are checked against your setup on partial and full swings, since technique often shifts between the two.

Common Misses

What a Wedge Fitting Can Fix

Chunking Shots From Soft Lies

Too little bounce for wet, soft turf lets the leading edge dig before the ball. Adding bounce or changing grind usually corrects this directly.

Bladed Shots on Firm Ground

Excess bounce on firm turf can cause the leading edge to skip into the ball. Lower bounce or a different grind restores control.

Uneven Distance Control

Wedges gapped too close together, or too far apart, make partial-shot distance control unreliable. Loft steps get corrected at the fitting.

Spin Loss in Wet Conditions

Worn or shallow grooves lose meaningfully more spin once moisture is involved — a common issue we check for during any wedge fitting here.

Fit Your Wedges for the Turf You Actually Play

Bring your current wedges and we'll test bounce and grind against real firm and soft lies before building anything.